Bridge Controller

GridNavigator’s Bridge an integrated hardware/software hub for web-based commissioning and remote managing capabilities required to control and optimize energy usage within the GridNavigator wireless EMS network. The GN Bridge communicates with “end point” devices such as the GN Sensor, GN Inside Fixture Controller, Programmable Time Switch, and/or the GN Smart Thermostat using radio frequencies over the secure wireless network. End point devices, on the other hand, send requests to the GN Bridge to establish an association or pairing communication. The radio range of a GN Bridge is about 1,000 ft. If more than one GN Bridge is necessary for greater coverage to control all the GN EMS end points in a network, additional GN Bridges can be connected in a daisy chain fashion.

Model #: GN-BR-001

Features Benefit
Wireless communication Easy installation for new buildings or for retrofits
No wires to pull through walls or conduit
Bi-directional signaling Acts as a gateway for continuous monitoring, optimizing, and control of HVAC and lights
Daisy-chain capability Complete coverage of large areas, even with multiple levels
Non-volatile memory Retains data—settings are not lost in the event of temporary power outages
LED indicators System status is easy to read even from a distance
High throughput / quick response design Maximizes customer comfort and energy efficiency
General Specifications
Power 24-volt DC from included power supply
Operating Conditions -40ºC to 65ºC
Storage Conditions -40ºC to 90ºC
RF Frequencies:
802.15.4 - 2.405 GHz – 2.48 GHz
Laird - 2.400 – 2.4835 GHz
For dimmer, light sensor, light switch for Smart Thermostat
RF Range 100 to 1000 ft. depending on architecture
Housing ABS plastic
Dimensions 6.62” wide, 3.30” high, 1.60” deep
Weight XXXX